Telis-4 RE Programming

1. To clear channel:  turn off power to motor for 7 seconds, on for 12 seconds, off for 7 seconds.  Then, turn on.  Motor will run for 5 seconds to confirm action.

2. Select the channel that screen originally was on by pressing lower button on front of transmitter.

3. Press and hold rear programming button for 2 seconds until motor jogs once and then continue holding for 8 more seconds until 2^nd jog.  This confirms that motor has been reset to factory mode. (Follow steps 1-3 for each motor you wish to remove from the transmitter.)

4. Select channel desired (Telis-4 only).  Wake up motor by pressing up and down buttons simultaneously.  Motor will jog momentarily.

5. Run screen to desired top limit by pressing up button.  (If screen runs in wrong direction,( i.e. goes down) press stop button for 5 seconds or until jog confirms new command.)

6. Press down and stop buttons simultaneously until motor starts to move down, then release.  Press stop button when desired bottom position is reached.  Press up or down buttons to set the position to exact location desired.

7. Press up and stop buttons simultaneously until motor starts to move up.  Release buttons and motor will stop at the previously selected top limit.

8. Press and hold stop button for about 5 seconds until motor jog which will confirm that both top and bottom limit settings have been recorded.

9. Press programming button on rear of transmitter until motor jog confirms programming on that channel is complete.

10. To add the same motor to another channel (Telis-4 only), “wake up” motor by pressing and holding programming button until motor jogs.

11. Select next channel desired and press programming button until motor jogs.  The motor is now programmed on both channels.

12. If limits are not quite correct, please see limit adjusting instructions attached.
(Must attach)