Solette (click for diagram)
Pocket Bracket

1. Determine the desired position of the installation brackets assuring that when installed that the position of the brackets will result in a level shade.  

2. Mark the brackets and drill holes with a drill bit.  Mount the motor brackets first with properly sized lag bolts.

3. Place the motor end of the tube in the motor bracket and rotate the idler end (pin end) of the unit into position while holding roller tube pin in the idler bracket in place.    

4. When properly positioned drill holes and secure the idler side with appropriately sized lag bolts.

5. Lower the screen all the way to the maximum drop desired and set the motor limits.

6. Run the screen up to the desired upper limit and again set the motor limit.

7. Run the screen up and several times to assure that it is tracking properly and that the limits are appropriate.

8. To install the side tracks determine the desired vertical line of the center of the track.  Install track brackets utilizing flat head screws centered on that line.

9. Slide hembar guides into the track and place back of track into the track brackets by twisting into place.  Tighten set screws to secure the track.  NOTE: The hembar should have play in it to be able to move left and right slightly to prevent binding up.

10. Again run the unit up and down several times to assure that it is not binding and limits are set properly.  Slight adjustments may be required in the tracks and limits to achieve desired operation.

11. Now you are Done.