President (click for diagram)
Stand Off Screen

1. Install mounting brackets 2” above the window and 4” in from end of box.  Mark and drill bracket holes with a 5/32” drill bit, then mount brackets with lag screws and tighten with a socket.

2. Take front off box then put the box centered on the brackets.  If unit is an interior crank run crankshaft through the crank and make a mark on the wall for drilling.  Remove box and drill a ½” hole through the wall.  Then replace box center it and tighten with T-bolts and nuts.  From the inside run crankshaft through the wall and into the crank.  Make a mark on the crankshaft of any extra shaft sticking out of the crank, pull it out and cut it off.  Reinstall crank and attach to the wall.

3. If the unit is tape operated first center the box tighten.  Drill your ½” hole directly behind where tape comes out.  Make certain the hole is clean and free of all sharp objects.  This should be through a stud if at all possible.  Run the tape through the wall, making sure the tape has no twist in it.  On the inside run the tape through the white plastic washer with the arrow facing up and the flat side facing out.  Run the tape through the tape lock.  Fasten the tape lock to the wall, then lower the screen all the way down.  Now cut off the pull tape at a comfortable level for the customer to reach, slip on the tassel and tie a knot to secure.  Raise the screen approximately 6” up.

4. Go back outside and slide the track brackets onto the tracks (small lock screw points towards the center.  Brackets should be approximately 4” up from the bottom of the track.  Lock the brackets into position by turning the small lock screw.  With each track brackets positioned, so the weight bar can move right and left, the brackets on the wall.

5. Pull the screen up, detach the foot (the part that attaches to the wall) from the extension (the part that attaches to the track).  Move the track slightly to one side, attach the foot to the wall with #8 screws, reattach the track with the extension, to the foot.  Repeat the process with the other track.

6. Run the screen to make sure everything runs great.  Reinstall lid and wipe unit down.